Free display tests that run in your browser. Nothing is uploaded.

Motion and timing

Black smearing test

Dark objects moving across dark backgrounds, which is the one case where a panel that looks fast everywhere else can fall apart.

Transition
The hardest transition for a slow panel, and the one to start with.

How to run this test

  1. Darken the room. Black smearing lives in the shadows and a bright room hides it completely.
  2. Press Go full screen and start the motion with the first pair, which is the hardest transition for a slow panel.
  3. Follow the moving block with your eyes rather than staring at a fixed point. A trail that follows the object is the smear.
  4. Step through the pairs. If the trail disappears once the object is much lighter than the background, you are looking at a dark-transition problem rather than general slowness.
  5. Raise the speed. Smearing gets longer with speed, and a panel that looks clean at 400 pixels a second can be obvious at 1600.

What a problem looks like

A dark trail behind the moving block
Black smearing. The pixels are taking too long to go from a dark level to a slightly lighter one, so the old state is still visible after the object has passed. It is the characteristic weakness of VA panels and gets worse as the panel gets colder.
Smearing only on the darkest pair
Typical and expected. Dark-to-dark transitions are the slowest on most panels, which is why this page starts there. If the brighter pairs are clean, the panel is fine at everything except the transitions that matter least often and are hardest to fix.
A bright trail rather than a dark one
That is overshoot, not smearing: the overdrive is pushing the pixel past its target and it settles back. Turn overdrive down a step. The ghosting test is the better page for tuning that, because it shows overshoot at several speeds side by side.
It gets better after the display warms up
Real and well documented on VA panels. Liquid crystal responds more slowly when cold. Give the display twenty or thirty minutes before judging it, especially in a cool room.
Everything smears, not just dark transitions
General slowness rather than a dark-transition problem. Check the overdrive setting first, since some panels ship with it off, and then compare against the ghosting test at the same speeds.

What to do next

If the dark pairs smear and the bright one does not, that is a dark-transition weakness in the panel. Overdrive can reduce it and cannot remove it, and a warm panel does better than a cold one.

Questions people actually ask

What is black smearing?

A dark trail left behind moving objects on a dark background. It happens when pixels change from a dark level to another dark level too slowly, so the previous frame is still partly visible. VA panels are known for it because their liquid crystal takes longer to move at the dark end of its range.

Why does it only show on dark content?

Because that is where the transition is slowest. The same panel moving from black to white can be several times quicker than moving from black to very dark grey. Dark scenes in games and films are where you notice it, which is also where it is most annoying.

Can overdrive fix it?

Partly. Overdrive pushes the pixel harder to reach its target faster, which helps dark transitions too. Push it too far and you swap the dark trail for a bright halo, which most people find worse. Tune it while watching this page and the ghosting test together.

Is this the same as ghosting?

It is a specific case of it. Ghosting is any visible trail from slow transitions. Black smearing is the dark-to-dark case, which behaves differently enough, and is bad enough on some panels, to be worth its own pattern.

Why is there no millisecond figure?

Because timing a pixel transition needs hardware that samples light far faster than a browser can observe. No API exposes it and nothing can infer it. What you get here is the transition itself, at a known speed, for your own eyes.