Free display tests that run in your browser. Nothing is uploaded.

Motion and timing

Frame skipping test

The marker strip you photograph to see whether your display is presenting every refresh, plus a live count of the frames this page itself dropped.

One marker moves one column per frame

Frames presented
0
Observed rate
—
Frames this page dropped
0
Worst interval
—

These numbers describe this page, not your panel. A clean run here is what makes the photograph worth taking.

How to run this test

  1. Press Go full screen and start the pattern. One marker moves one column per frame, so every refresh gets its own position.
  2. Watch the live readout first. Dropped frames counted here are frames this page failed to present, which is a real measurement of the page rather than the panel.
  3. For the panel itself you need a camera. Set a phone to a shutter speed around 1/100 second, or use its slow-motion mode, and photograph the strip.
  4. Count the bright marks in the photograph. A display that is not skipping shows an even run of them. A skipping display shows a gap or a doubled mark where a refresh was dropped.
  5. Repeat at each refresh rate your display offers. Skipping usually appears only at the highest rate, which is the point of the test.

What a problem looks like

A gap in the photographed run of markers
A refresh cycle produced no new image, which is frame skipping. It usually means the display is accepting a signal at a rate it cannot actually present, most often the top rate over a marginal cable or through an adapter.
The live dropped count climbs steadily
This page is failing to present frames, which is a browser or system problem rather than a panel one. Close other tabs, check hardware acceleration, and try again. A page that cannot keep up cannot tell you anything useful about the display.
Skipping only at the highest refresh rate
The classic result. Try a different cable, a direct connection rather than an adapter or hub, and a lower colour format or bit depth if the display offers one. Bandwidth is the usual constraint.
The photograph shows a smear rather than distinct marks
The shutter was too slow. Shorten it, or use slow motion and step through frames. On a bright screen 1/250 second is a good starting point.
Everything looks fine in the photograph but motion still looks wrong
Skipping and stutter are different faults. Uneven frame pacing with no skipped refreshes still looks bad and is measured directly by the frame rate test, which reports jitter rather than counting marks.

What to do next

If the photograph shows skipped refreshes, change the cable first, then remove any adapter or hub, then try a lower colour format. If it shows none but motion still looks wrong, the frame rate test measures pacing directly and is the better page.

Questions people actually ask

What is frame skipping?

A display accepting a signal at one rate while presenting fewer images than that rate implies. A monitor advertised at 165 Hz might take the signal and show only every other frame on part of the range, which makes motion look worse than at a lower rate that it handles properly.

Why do I need a camera?

Because the skipped frame happens inside the display, after the browser has handed the image over. Nothing in a web page can see what the panel presented. A camera can, because it records what actually came off the screen during the exposure.

What do the live numbers tell me then?

They tell you whether this page is presenting frames evenly. That is a genuine measurement, taken from the animation loop itself, and it is a necessary condition: if the page is dropping frames, nothing you photograph will mean anything. It is not a measurement of the display.

What shutter speed should I use?

Fast enough to catch a few refreshes rather than a smear. Around 1/100 second is a reasonable start at 60 Hz, and shorter at higher rates. Phone slow-motion modes work well because you can step through the result frame by frame.

Is frame skipping common?

It is uncommon on a display used within its rated limits over a good cable, and much less rare at the very top of a panel range or over a long or cheap cable. It is worth checking once when you set up a high refresh rate display, and not worth worrying about after that.