Guide
How far you can calibrate a display by eye
You can get a display from clearly wrong to reasonably right with patterns and your eyes. You cannot profile it, and the difference is worth understanding.
Last updated
What you can do by eye
Set brightness for your room, using a sheet of white paper as a reference point.
Set contrast so the highest steps below white stay separate, which stops highlights clipping.
Find a black level that keeps shadow detail without lifting black, using a near-black ladder.
Spot an RGB range mismatch, which is the single most common picture fault and is free to fix.
Judge roughly where your white point sits by comparing against standard references side by side.
Spot banding, crushing and clipping, all of which are visible against known patterns.
What needs an instrument
Any number. Brightness in nits, contrast ratio, white point in kelvin, gamma as a curve rather than a single point, colour accuracy as delta E, gamut coverage as a percentage. All of these need a colorimeter or a spectrophotometer measuring light from the panel.
A colour profile. Software can only correct what has been measured, and building the correction is the whole job of a calibration device.
Uniformity as data rather than an impression. Measuring how the panel varies means measuring many points under controlled conditions.
No browser can do any of this, which is why nothing on this site reports a figure for any of it.
The order to adjust in
Pick the least processed picture mode first, usually Standard or sRGB. Everything after this depends on it.
Set the RGB range at both ends so they match. Doing this later invalidates everything you set before it.
Set brightness for the room, then contrast for highlight separation. In that order, because contrast interacts with the top of the range and brightness with the bottom.
Check the near-black ladder and adjust the black level or brightness slightly if the lowest steps are missing.
Only then look at colour temperature, and only with the RGB gains if a preset does not get you close.
Leave sharpness at its neutral position, which on most monitors is the middle of the range rather than zero.
The tools for this
- Grayscale test A ramp and step wedge for crushed blacks, clipped whites and banding.
- Black level test A PLUGE ladder that shows whether your blacks are being crushed.
- Contrast test Checkerboard and step patterns for shadow and highlight separation.
- Colour temperature test Warm and cool white points side by side, as sRGB approximations.
- Gamma test Pixel-line reference against grey patches, for an honest gamma estimate.
Questions people actually ask
Is a cheap colorimeter worth it?
If colour accuracy matters to your work, yes, and it will do more in ten minutes than hours of adjustment by eye. If you mostly want the display to stop looking wrong, patterns and the order above get you most of the way for nothing.
Can I use someone else’s profile for my monitor model?
It is better than nothing and worse than measuring. Panels vary between units and drift with age, so a profile made from another unit corrects for that unit. Treat it as a starting point rather than a calibration.
How often does a display need recalibrating?
Panels drift with use, more quickly in the first few hundred hours. For professional work, monthly is a common interval. For everything else, once when you set it up and again if something changes is fine.