Guide
Limited and full RGB range, and why blacks look grey
Washed-out blacks and missing shadow detail are usually not the panel. They are two ends of a cable disagreeing about what the numbers mean.
Last updated
What the two ranges are
Full range uses all 256 code values, 0 to 255, where 0 is black and 255 is white. This is what computers use by default.
Limited range uses 16 to 235, reserving the values above and below for signal headroom. This comes from broadcast television and is what most video content and many HDMI devices use.
Both are valid. The problem is only ever a mismatch: one end sending one and the other end expecting the other.
What a mismatch looks like
Source sends limited, display expects full: blacks look grey and washed out, whites look dull, and the whole picture lacks punch. This is the common one, and the one people usually blame the panel for.
Source sends full, display expects limited: blacks crush together and shadow detail disappears, while highlights clip. Everything below code 16 becomes the same black and everything above 235 becomes the same white.
The near-black ladder makes both obvious in seconds. If the first several steps above black are invisible, you are crushing. If black itself looks like dark grey, you are lifting.
Where to change it
On an Nvidia graphics card, the output dynamic range setting sits in the control panel under display settings. On AMD it is called pixel format. On Intel it is under the display colour settings.
On a television, the setting is usually called HDMI black level, black level or HDMI RGB range, with options such as Low, High, Normal, Enhanced or Auto.
On a games console the setting is in the video output options, and it must match whatever the display is set to.
The rule is simple: make both ends agree. Which one you pick matters far less than that they match.
Why Auto is not always the answer
Auto settings negotiate through the display identification data, and that negotiation fails often enough that manual is more reliable. Adapters, splitters, receivers and long cables all break it.
If the picture changes when you switch inputs or after a firmware update, the negotiation is being redone and getting a different answer. Setting both ends manually stops that happening.
The tools for this
- Black level test A PLUGE ladder that shows whether your blacks are being crushed.
- Grayscale test A ramp and step wedge for crushed blacks, clipped whites and banding.
- Contrast test Checkerboard and step patterns for shadow and highlight separation.
- Black screen Pure #000000, for bleed, glow, dust and OLED black level.
Questions people actually ask
Which should I use, limited or full?
For a computer connected to a monitor, full at both ends. For a games console or a media player connected to a television, limited at both ends is the safer default because it matches the content. The important thing is that both ends agree.
How can I tell which one is wrong without changing anything?
Run the near-black ladder. If the lowest steps are invisible, something is crushing below 16. Then run a black field: if it looks grey rather than black in a dim room, something is lifting. The first says the display expects limited, the second says it expects full.
Does this affect colour as well as brightness?
Yes. Compressing or stretching the range moves every value, so saturation and hue shift with it. A picture that looks both washed out and slightly off in colour is a strong hint that a range mismatch is the cause.