Guide
What to check on a new monitor, in order
A return window is short and the faults that matter are not the ones people usually look for first. This is the order that finds them.
Last updated
Set it up properly first
Set the monitor to its native resolution and its highest refresh rate in the operating system display settings. Neither happens automatically, and testing at the wrong resolution wastes the whole exercise.
Use the cable that came with it, plugged directly in. Adapters and hubs are where refresh rate and colour depth quietly get negotiated down.
Choose the least processed picture mode, usually called Standard or sRGB, and turn off anything named dynamic, eco or vivid.
Let it warm up for twenty minutes. Panels shift as they reach temperature, and a cold VA panel in particular looks slower than it really is.
The order that finds faults fastest
Dead pixels first, because they are binary and quick. Nine full-screen fields, starting with white.
Backlight bleed and uniformity second, in a dim room at your normal brightness. These are the two most common reasons a panel comes back.
Refresh rate third. Measure it rather than trusting the settings dialogue, and check for skipped frames if it is a high refresh rate model.
Black level and greyscale fourth, which will also expose an RGB range mismatch if there is one.
Motion last, because tuning overdrive takes longer than everything else put together and is pointless if you are going to return the panel anyway.
What is worth a return
Visible bleed or clouding on dark content at normal brightness from your normal seat. Not bleed you can find in a pitch-black room with the brightness at maximum.
Dead or stuck pixels outside the manufacturer policy for that model, which you should read rather than guess.
Obvious dirty screen effect on moving content, which is the fault people regret most after the window closes.
Frame skipping at the advertised refresh rate over the supplied cable.
Anything that is clearly worse than a second unit of the same model, if you are in a position to compare.
What is not worth a return
IPS glow in the corners. Every IPS panel has it.
Some unevenness on a flat grey field. Every panel has that too, and a moving grey field is the harshest test there is.
A single dead pixel on a large panel, if it is within the policy and you cannot see it on real content.
Backlight bleed that only appears in a completely dark room at maximum brightness.
The tools for this
- Monitor test A ten-step guided inspection covering pixels, bleed, tone, motion and resolution.
- Dead pixel test Nine exact full-screen fields, so a bad pixel has nowhere to hide.
- Backlight bleed test Black field plus the bleed, glow and clouding distinction most sites skip.
- Refresh rate test Median-based Hz measurement, with jitter and dropped frames.
Questions people actually ask
How long should the whole check take?
Twenty minutes for the essentials, and an hour if you tune motion settings properly. The guided monitor test walks the essentials in a sensible order and keeps a summary of what you decided at each step.
Should I test before or after updating firmware?
After, if an update is available. Monitor firmware updates occasionally change overdrive behaviour, variable refresh rate handling and range negotiation, and you want to judge the version you will actually be using.
Is it worth buying a second unit to compare?
Panel lottery is real, especially for bleed and uniformity, and comparing two units of the same model tells you far more than any review can. It is only worth the hassle if both can be returned easily, which varies by retailer.