Guide
The display settings that actually matter for games
Most of the settings on a gaming monitor do nothing useful. These are the ones that do, in the order to set them.
Last updated
Set these first
Refresh rate, explicitly, in the operating system display settings. Nothing else on this list matters if the panel is running at 60 Hz because nobody told it otherwise.
Resolution at the panel native value. A scaled signal softens everything and no sharpness control puts back what scaling removed.
Variable refresh rate on, if your display and graphics card both support it. It removes tearing without the input lag vertical sync adds.
A frame rate cap slightly below your maximum refresh rate, which keeps you inside the range where variable refresh rate behaves best.
Then tune these by eye
Overdrive, using moving objects at the speed you actually play at. Strongest setting with no bright halo in front. This is the one that most rewards care.
Black level or brightness, so shadow detail survives. Games are full of dark corners and crushing them is a competitive disadvantage as well as an aesthetic one.
Backlight strobing, last and only if you want it. It sharpens motion, costs brightness, usually cannot run with variable refresh rate, and bothers some people.
Skip these
Dynamic contrast. It changes the backlight based on content, which means the picture shifts while you play.
Black equalizer and similar shadow-lifting modes, unless you accept what they do: they raise the whole low end, which makes dark areas readable and flat. Some players want that trade and it is not a picture improvement.
Sharpness above its neutral position. There is no detail to recover from a native-resolution signal, so anything it adds is invented.
Any preset named after a genre. They are colour and contrast changes with a label, and none of them know what you are playing.
The input side
Polling rate on your mouse, set in the manufacturer software and then measured rather than assumed. A 1000 Hz mouse reporting at 125 Hz is common and undoes a lot of what a fast panel gives you.
A direct USB port rather than a hub, and a wireless receiver set to the same rate as the mouse.
None of this site can tell you whether a change is worth it to you. It can show you the same motion at each setting, which is a better basis than a forum argument.
The tools for this
- Refresh rate test Median-based Hz measurement, with jitter and dropped frames.
- Ghosting test Moving objects at several speeds, for trailing and overshoot.
- Frame rate test Live FPS, 1 per cent lows and frame pacing under a chosen load.
- Mouse polling rate test Real sampling rate from coalesced pointer events, not one reading per frame.
Questions people actually ask
Does vertical sync add input lag?
Yes, because frames wait for the next refresh before being shown. Variable refresh rate solves the same tearing problem without that wait, which is why it is the better option when both ends support it.
Should I cap my frame rate?
Inside a variable refresh rate range, a cap a few frames below the maximum keeps you in the range where it works properly and avoids falling back to vertical sync behaviour. Outside that range, capping mostly saves power and heat.
Is backlight strobing worth using?
It genuinely sharpens motion by shortening how long each frame is held. It also halves brightness or worse, usually disables variable refresh rate, and produces visible flicker that some people cannot tolerate. Try it and decide for yourself.