Free display tests that run in your browser. Nothing is uploaded.

Guide

Response time, overdrive and what actually causes blur

Response time is the most quoted and least useful number on a monitor box. Here is what it means and what actually causes the blur you see.

Last updated

What the rating means

Response time is how long a pixel takes to change from one level to another. Manufacturers quote grey to grey, because it is faster than black to white on most panels and produces a smaller number.

The conditions are chosen by the manufacturer: which levels, what overdrive setting, and what counts as finished. Two panels with the same rating can behave very differently.

No web page can measure this. Timing a pixel transition needs a photodiode sampling thousands of times a second, which is why review sites use dedicated hardware.

Most blur is not the pixels

On a sample-and-hold display, each frame is held until the next arrives. Your eye tracks a moving object smoothly across that held image, which smears it across your retina.

This hold-type blur dominates on modern panels. It scales with how long each frame is held, which means it improves with refresh rate and not with response time.

Backlight strobing attacks it directly by switching the backlight off between frames, which shortens the hold. It costs brightness, usually cannot run with variable refresh rate, and gives some people headaches.

Tuning overdrive properly

Overdrive pushes a pixel past its target voltage so it arrives faster, then lets it settle. Done well it shortens trails. Done too hard it overshoots, and you see a bright halo in front of moving objects instead.

The right setting is the strongest one with no visible halo. On most monitors that is the middle option, whatever the top one is called.

Tune it at the speed you actually use, and with the panel warm. A cold panel needs more overdrive than a warm one, which is why a setting chosen in the first five minutes often looks wrong an hour later.

When dark transitions are the problem

VA panels are slowest going from one dark level to another, which produces a dark trail behind objects on dark backgrounds. It has its own name, black smearing, because it behaves differently from general slowness.

It gets worse when the panel is cold and better as it warms. Overdrive reduces it and cannot remove it.

If a panel is clean on bright transitions and smears on dark ones, that is the signature, and no setting will fully fix it.

The tools for this

Questions people actually ask

Is 1 ms better than 4 ms?

Not reliably. The conditions behind those numbers differ between manufacturers, and a 1 ms rating often involves overdrive strong enough to overshoot visibly. Looking at moving objects on your own panel tells you more than either figure.

Why does my monitor still blur with a fast rating?

Because hold-type blur is doing most of the work, and it depends on refresh rate rather than pixel speed. A higher refresh rate or backlight strobing reduces it; a faster panel at the same rate does not.

Should I use the strongest overdrive setting?

Almost never. Past the right point you trade a soft trail for a bright halo in front of the object, which most people find more distracting. Step up one level at a time and stop when the halo appears.