Free display tests that run in your browser. Nothing is uploaded.

Colour and tone

Colour accuracy test

Reference patches, grey steps and the colours your eye knows best, shown together so you can judge reproduction without anyone inventing a number.

Light skin
Mid skin
Deep skin
Sky blue
Foliage green
Ripe tomato
Chart

Colours your visual system has strong expectations about.

How to run this test

  1. Turn off every picture enhancement first: vivid modes, dynamic contrast, colour boosters and any night-light filter. All of them change what you are about to judge.
  2. Let your eyes settle for a minute in the room you actually use. Colour judgement is almost entirely about adaptation.
  3. Press Go full screen on Grey neutrality. Any grey leaning warm or cool is a white balance error, and that affects every other colour on the screen.
  4. Switch to Memory colours. Skin tones are the harshest test there is, because you have seen a great many faces and your brain objects immediately when one is wrong.
  5. Finish on Saturation steps. On a display that oversaturates, the three steps of each colour collapse towards each other instead of separating cleanly.

What a problem looks like

Skin tones look orange, or too pink
Almost always a white point problem rather than a fault in the reds. Check the grey patches first: if they lean warm, the skin tones will follow. Fixing the grey fixes both.
Greys are not neutral
The three channels are out of balance. A preset named sRGB or standard is the first thing to try, and the RGB gain controls in the display menu are what actually correct it when a preset does not.
The saturation steps barely differ
The display is pushing saturation, so colours that should be distinguishable are being pinned near the edge of the gamut. It is usually a vivid or dynamic picture mode, and it is the single most common reason a screen looks impressive and reproduces badly.
Colours look right here and wrong in one application
That is colour management rather than the panel. An application that ignores the display profile shows different colours from one that respects it, which is why the same photograph can look different in two programs on one screen.
Everything looks slightly off and you cannot say how
Check a printed photograph or a real object under daylight beside the screen. Your eye is far better at comparison than at absolute judgement, which is the whole reason these patches are shown together rather than one at a time.

What to do next

Fix grey neutrality first, because every other colour follows the white point. Then check the saturation steps in each picture mode and keep the one where they separate cleanly. A colorimeter is the only way to go further than this.

Questions people actually ask

Why is there no delta E figure here?

Because delta E is the measured difference between a colour that was asked for and the colour a panel actually produced, and measuring the second half needs a colorimeter pointed at the screen. A browser sends values and has no way to see what came out. Any web page quoting you a delta E has invented it.

So what is this page actually good for?

Finding a display that is clearly wrong, and comparing before and after a settings change. Those two things cover most of what people want. What it cannot do is certify a display as accurate, which is a different question needing different equipment.

Why memory colours rather than a standard colour chart?

A colour chart is a set of physical patches with measured values, and photographing one onto a screen does not make the screen show those values. Memory colours work the other way round: they rely on your own strong expectations about skin, sky and foliage, which are expectations no calibration equipment is needed to have.

My display has an sRGB mode. Should I use it?

For general use and for anything that is not colour managed, usually yes, because it constrains a wide-gamut panel to the space nearly all content is authored in. The trade is that it often locks brightness and other controls. Check the grey patches in it and in the default mode and use whichever is more neutral.

Can I calibrate my monitor with this?

You can get it from clearly wrong to reasonably right, which is worth doing and is not calibration. Calibration means measuring the panel and building a correction profile from those measurements, and that needs an instrument. The guide on calibrating by eye sets out exactly where the line falls.